Posts

Showing posts from November 30, 2014

Large Ring Lift

Image
After seeing my massive marble machine ring lift I was asked to replicate the lift only to make a lifting mechanism for golf balls. This one needed to be motorised, slightly larger but didn't need the spiral so I basically ended up redrawing the whole thing. There was a minor issue with the drive gear shaft shearing off so I replaced the gear with an acrylic version and it seems to be running fine. It works well though and I can't wait to see the rube goldberg it's going to be used in.

Christmas Badge Round up

Image
I made 6 badges in total but these are the four I am now listing in my web stores, it's not too late to get them for Christmas.  The amusing thing about working on tiny scale items in a massive laser  is that the honeycomb bed just becomes additional work surface and you can keep multiple sheets of wood/veneer ready for cutting on the bed.  

Christmas Badge 6

Image
I saved the best for last. I'm really pleased with the stripey candy effect and the blue ribbon.

Christmas Badge 5

Image
Another 1 from the trio , I learnt my lesson and simplified this a little. The nose is still 1.5mm wide so it is in danger of being lost. The blue wood veneer is great.

Christmas Badge 4

Image
This is the same tree from the Christmas Trio but obviously much smaller. Too small in fact, the dots are 2mm wide and the strips are 1.5mm wide. It's a nice badge but I don't want to make more than one.

Christmas Badge 3

Image
There is a small etch all round the edge of these holly leaves. It make a big difference to the final piece but it did increase the cutting time from seconds to 2 minutes, worth it though.

Christmas badge 2

Image
Not entirely happy with the alignment of these veneers, they slipped while gluing but also not very happy with the overal design so will abandon this one here.